Umarex RWS Lock Down Scope Mount for Air Rifles, 1-Inch Rings

what our customer say this product:

Powered by

1. Anonymous Verified Buyer – 30 April 2024

   Good solid mount that fits perfectly on a Diana model 34 and is the exact length of the factory scope base and the mount lines up perfect with the barrel droop common with Diana air rifles ….sits a little higher than expected but that’s no big deal as I’m switching the scope from a 4×32 to a variable power AO scope with a 40mm objective so the height of this mount will definitely accommodate the new scope
   

2. Charles Verified Buyer – 6 June 2024

   Super tight for my marlin 795
   

3. Kurt Landfors Verified Buyer – 5 October 2024

   Purchased to mount a Hawke Airmax 4-12×40 scope on a HW97K. The mount is excellent quality, but I knocked off 1 star because it is wider than the scopes I was interested in. With simple modification to the mount (with a rounded file) I was able to adapt it to the Hawke 4-12×40, but it was just too big for the 3-9 and 2-7 scopes. So… I am happy with this mount for my specific application, but if I decide to go with a lower power scope from Hawke, I will need a different mount. The maximum tube mount length is 4.7″. The Hawke 4-12 is 4.75″.

   

4. Rowland Parks Verified Buyer – 9 November 2024

   I bought this to put on a Diana RWS 34. It fit well enough. It did scratch my rail. I also couldn’t get either of the adjustable recoil lugs to fit any of the holes in the rail. It’s 4 3/4″ long. Make sure your scope will fit before you buy. A lot of decent quality airgun scopes will not.
   

5. sarah Verified Buyer – 13 November 2024

   Excellent product fast shipping
   

6. William A. Parmley Verified Buyer – 18 February 2025

   I am using this mount on my Diana 34 airgun. It is a perfect fit and looks good on the rifle. I have shot about 250 rounds with it installed and so far neither the mount or scope have slipped. Many reviewers express concern that the rings only use two screws, but they have sticky little rubber pads inside that grip the scope tube quite well and so far have kept mine from slipping, and the rings are not as bulky as the four-screw type. As far as droop compensation goes, I did have to dial in a little “down” with my scope, but not too much, so the mount seems to be doing the job in that respect. This is definitely the type of mount you need for a break-barrel spring gun to compensate for droop and to withstand recoil, since it has two stop pins that engage the holes in the RWS scope rail. (Note: after buying this I saw a similar mount at Pyramid Air that is made to overlap the front of the RWS scope rail and so should withstand recoil even better. That would be worth a look if you have any concern about that, but so far — 250 rounds — I have no problem with this one.)
   

7. Anonymous Verified Buyer – 19 March 2025

   the best and most secure scope mount out there, very happy and will buy more for sure.
   

8. Tom W Verified Buyer – 25 March 2025

   Arrived taped up and missing part of the piece that attaches to the dovetail as well as all but one screw.

   

9. Stephen L. Verified Buyer – 2 April 2025

   I have an RWS air rifle and tried using traditional scope rings with my air rifle scope. Didn’t work well; all kinds of problems with accuracy and the scope going out of alignment. Did some research and found these. Super easy to install, very secure, and my scope is now spot on. Took a few minutes to sight in and it hasn’t budged sense. Wish I had started with these when I decided to move away from the iron sights!
   

10. Anonymous Verified Buyer – 1 May 2025

    This is really a sturdy airgun scope mount ready made for the 11mm grooves on your airgun Its heavy duty german made with the required wrenches for installation and its a little higher than most so your scope is not too low along the barrel and having your manual rear sight in the scopes view. I even use these on all my 22 rifles as any 1″ scope fits perfectly and I have never had one come loose.
    

11. Kindle Customer Verified Buyer – 5 May 2025

    I needed a good drop compensating mount for a Walther Parrus, and thought this was the answer. After about 150 rounds I saw that the mount was slipping rearward, even with the stop pin engaged. When I pulled the mount I saw that the stop pin was deforming the aluminum base and that it was allowing the pin to tilt back. This base should be steel , not aluminum, and the stop pin should be a larger diameter for more bearing area in the mount and on the rifle. This may work OK on an RWS rifle that has a separate dovetail base on top of the receiver that allow both stop pins to be used, on rifles with the dovetails milled into the receiver and only one pin hole it just cant take the recoil.

    

12. neonleon Verified Buyer – 11 May 2025

    I mounted this on a Marlin Glenfield Model 60 that had a tip on mount. This is a inexpensive solution to mounting a scope on this gun. I wanted to mount a 1 inch diameter scope and even though this is listed as an airgun scope mount it works fine on model 60. I have shot 400 rounds on the rifle since mounting and the scope held zero. I mounted scope with Laser bore sight tool and when I got to the range i had it zeroed at 25 yards within 5 shots. This tells me that this mount goes on straight/ Highly recommend if you own a model 60. I learned about it on YouTube.
    

13. C Sword Verified Buyer – 13 May 2025

    Built like a tank. Heavy as a tank. Made a heavy rifle notably heavier. Despite the weight it’s still a 5/5. How RWS manufactures this and retails it for 25 dollars is a mystery. Well made. Has not moved since initial install. Does not mar scope finish. Taper kept elevation scope dial reasonably centered despite Diana barrel sag. If they made it in aluminum version it would be so much better. It really does weigh more than the target scope that’s mounted in it. No other critiques.
    

14. Larry C. Verified Buyer – 11 June 2025

    Had to return. This is for flat top receivers only. Not mentioned in the description but now I find it mentioned in the reviews by a previous buyer. other than that it looks fine.